Datasheet:Expeller

Model: SGC120

Capacity

Sunflower

120 kg/hr

*Capacity is dependent on quality and type of seed, moisture, whether de-hulled or not, whether ground, conditioned etc.


Main motor 11kW
Motor RPM 4 pole 1460RPM
Hopper size Approx. 50lt.
Feed adjustment

Manual

Cutter Cutter Blades Standard Included
Feeder auger Included standard.
Electrical

3 Phase 380V

All motors are 3 phase 380V Volt, 50 Hz unless otherwise indicated

Dimension & Mass

Dimensions

On Stand

Shipping

Length 1700mm 1840mm
Width Body: 470mm 1100mm

Body with discharge plate: 685mm

 
Height Top of hopper: 1950mm 910mm
Center of screw: 1150  
Mass 600kg.  
Height of oil and cake at exit ±995mm  

Spare parts & Consumables

Screw
Plates
Pressing rings & bearings
V-Belts




Before starting the oil press feeder

Make sure that the hopper is free of any foreign matter.

Set the varispeed unit to its lowest setting.

Make sure the outlet of the auger is placed over the heater to prevent spilling.

Ensure that the forward and reverse selector switch is set to forward.



Before starting the oil expeller

Make sure that the clamping nuts are loosened on the cake adjusting head and that there is a gap between the cake discharge ring and the cake adjusting head

Make sure that the inlet of the oil expeller is clean and free of any seeds or foreign matter.

 

Note: It is prohibited to start the oil expeller if there is no clearance between the cake adjusting head and cake discharging ring. When starting the feed should not be too rapid. Metallic matters are prohibited to enter the squeezing chamber. The feeding inlet should not be poked by metal bar.







Technical specifications may be altered without notice. All capacities shown are indicative only